Deep Casting Epoxy resin Pourpoxy Layers up to 10 cm
Deep casting epoxy is Mainly used for making River tables, Filling moulds an incapsolating funiture or products.
Always wear protection when using Epoxy!
This is the Deep casting epoxy resin you need to create beautiful resin river tables. due to its main property to pour deep layers it is great creating tables. Create beautiful masterpieces yourself!
Super easy mixing ratio!
✔Crystal clear Epoxy
✔Casting up to 5 CM no matter the surface size.
✔UV stabilized long brightness guarantee
✔Good adhesion to substrate.
✔Water resistant after curing.
✔Use outdoors after curing due to its UV resistance.
✔Self-ventilating and leveling.
✔Low viscosity causing bubbles to rise to the surface.
✔Casting up to 10 CM in the right conditions.
✔Easy to color with Pourpoxy Pigments.
✔2:1 mixing ratio by weight
✘Cannot be cast thin. Use this deep casting epoxy resin for casting above 1 CM.
✘ Not recommended to pour transparent under 1 cm in height on a bigger surfaces.
✘ Long curing time 5-6 days.
Deep casting epoxy resin from Pourpoxy
It is a casting resin based on epoxy resin which indicates that a chemical compound mixed together hardens the material. This is done by mixing the B-component with the A-component.
The casting resin is intended for transparent castings up to 5 cm regardless of the size of the surface. Therefore, it is suitable, for example, for tables, river tables, filling moulds or pouring in a log table.
This layer protects and gives a beautiful glass-like appearance. With a thick layer of epoxy deep casting resin you can turn your old and worn table into a work of art again. Moreover, the casting resin contains a UV Blocker. This ensures that your casting has a high UV resistance and can therefore also be used outside the house when cured.
The maximum height of 5cm can be exceeded when casting in a mould of small surface area. You can cast up to 10 cm in a 20 X 20 cm mould at a room temperature of 20 degrees. For larger moulds it’s recommended to cast in multiple layers.
TIP: First of all, make sure that the object you want to cast is level.
Our Thick layers of casting resin are easy to use. The product comes in 2 parts. 1 part A-component Epoxy and 1 part B-component hardener. Before casting your project these parts need to be mixed with each other.
The mixing ratio of this product 2 Parts A : 1 Part B
Pour your project in a dry and clean location with a minimum processing temperature of 15 degrees and a maximum of 25 degrees.
The use of mixing spatulas as opposed to an electric mixer is recommended to ensure that the product remains airless. This ensures that there are fewer air bubbles in your product. During the pouring you will experience that air bubbles rise to the surface. You can easily make these bubbles disappear by going over them with a gas burner. Do this about 2 to 3 times. Or try one of the other ways you can find here.
RECOMMENDED TO MIX THE PRODUCTS IN A MIXING CUP OR BUCKET.
When using epoxy always wear protection like gloves and safety glasses! If you are not in a ventilated area use a respirator!
TIP: Use the Pourpoxy Table Top epoxy to seal your table after the big pour for a high gloss result.✔
Check out the link to find out What epoxy you need?.
For any other questions about the product or applicability send us a message!
What do you get?
With an order of the Pourpoxy Deep casting Epoxy you will receive: